Safety Razor is the best way to provide terrific shaves efficiently. Therefore, it’s your objective to keep your safety razor looking and performing well in its entire service life. The safety razor is made of metal that corrodes most of the time. Its safety measures, coating, and cleaning will enhance its endurance (or at least slow down its deterioration).
If you use a safety razor, keep an eye on its maintenance. You should keep your razors in excellent condition to prevent yourself from contagious bacteria, germs, and diseases.
A periodic maintenance procedure consists of several levels. How often you apply these safety measures depends upon a few factors. These factors include the mineral content of your water (either soft or hard it is), the metallurgy used in the razor and its blade, also how you take care of it on a daily basis.
Here is a guide on How to clean your safety razor?
1 Rinse After Every Use
Right after using the razor, you should clean it. For this, rinse it thoroughly with warm water and wipe it dry with a clean towel. Thus, the razor will stay clean, and the water will not build up minerals from the lather. For an extra level of hygiene, thoroughly rinse and wipe the razor head inside after every blade change.
2 Keep it Dry
Another essential measure to keep your safety razor stands for more time, dry its blade and body instantly after use. Although this step takes a few seconds, in return, it will extend its service life.
3 Perform a Weekly or Monthly Cleaning
Furthermore, you should clean your razor more thoroughly on a regular basis. Depending on your water type, you should perform this once a week if you have “hard” water or monthly if your water is “soft.”.
Here are the things you need to clean your safety razor:
- The Laundry soap
- Water
- A toothbrush with a soft bristle
- Soft Rag
To clean the individual razor’s parts, you must disassemble them first and then fill your sink with hot, soapy water. Clean each piece with the rag dipped in water. If there’s a hard-to-reach place, use a toothbrush. Always remember to use soft bristles. Alternatively, a cotton swab or even a toothpick with gentle pressure may be useful in reaching some areas.
4 Perform a Deep Cleaning as Needed
You can soak the razor parts in a vinegar solution to dissolve minerals and scum. To make the vinegar solution, mix one part of vinegar with four parts of water and soak the razor pieces for ten minutes. After that, use a rag or toothbrush to clean the razor.
In addition to vinegar, you can also add baking soda to form a paste. Then scrub this paste with the help of a toothbrush. Remember, do not use vinegar directly on the stainless steel blade. Before using vinegar, dilute it with water. In high concentrations, vinegar can corrode stainless steel. You might try it out first on an inconspicuous area of the razor.
Afterward, rinse the razor under warm water and then allow it to air dry completely before reassembling it. Pay close attention to the threaded post on the top cap of a two- or three-piece razor. Use Vaseline, grease, or oil to lubricate the threads. You can also wrap Teflon tape around the thread. Hardware stores and department stores tend to carry Teflon tape in their plumbing supplies sections.
Make sure to clean all the scum between the threads. For this purpose, you can use an old toothbrush and soapy water. Wrapping the tape once is enough.
How to Shave with a Safety Razor?
Here, we will provide you with some basic tips on how to use a safety razor?
- Identify the direction in which hair grows
- The first step in shaving is to prepare your skin
- Always use shaving cream, gel, or even a hair conditioner when you shave.
- Orient your razor in the direction where the hair grows
- A second pass will give you a closer shave
- After you end the shave, apply lotion or balm
That’s it; you’re done!
